mobilitycas.blogg.se - Autodesk inventor cam 2022

Fixed an issue with certain profile roughing toolpaths where the generation should result in an error and empty toolpath instead of a crash (#29590).

Fixed an issue with certain turning profile roughing toolpaths where the tool left too much material on the model when the "extend to stock" parameter was turned on (#28809).

Fixed an issue with certain turning profile finishing toolpaths where the retract move gouged through the solid model (#29808).

Fixed an issue with certain turning profile finishing operations with no dragging turned on where the clean up pass was entering vertically instead of at an angle (#29785).

Fixed a problem with certain turning profile finishing toolpaths that were giving an exception error instead of an empty toolpath (#30197).

Fixed an issue with certain turning profile finishing toolpaths where the top of the model was not being machined when tangential extensions were specified (#27892).

Fixed an issue for wrap toolpaths in which the wrap radius was not updated when choosing the cylinder and the operation could not be accepted.

Added diagnostic information to the log when an adaptive toolpath fails to produce any result because the ramps are too large.Fixed an issue where the holder could collide with the remaining stock when rest machining and reduced air cutting were enabled.

Fixed a potential crash in rest machining when a previous stock level with stock gets completely cleared at a later stage.

Fixed an issue where rest machining for pocket clearing did not remove all accessible stock in some cases.

Reduced the likelihood of pocket clearing toolpaths gouging when attempting to enter a slot of similar width to the tool diameter.

Fixed several crashes that could occur in specific parts when using parallel or contour strategies.

Fixed an issue where the adaptive clearing toolpath could crash or hang when the reduced air cutting feature flag was enabled.

Fixed a potential stock collision due to missed machining levels which could occur in some cases of adaptive clearing.(#26891).

This may increase in tool-wear as the entire pocket is included in the remaining stock in this operation." (#22621) The message is also updated to "Warning: A pocket, which was not machined by previous operations because they used tools that were too large, has now been fully machined in this operation.

The warning message "Skipping a pocket since the rest tool has not removed any material" will now only show when a pocket was untouched by the rest tool, and the entire stock is left for the rest operation.

Installation WHAT’S NEW The following changes have been made in the current update (2022.2): This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2022.2 Release Notes